ECP 300 EXPERT VD3 LIGHT MONO (cod.110300EVD3M1)
110300EVD3M1
New product
Electrical board for single-phase refrigerating installation, up to 2 HP max 10 A - ventilated - electrical defrost - magnetothermic protection accessible through front panel - PEGO electronic control
Data sheet
| Main Function | Full cold room management |
| User interface | Red Led big (Base/Expert series) |
| Datalogger | No |
| General protection | Magnetothermic |
| Compressor - type | Single phase |
| Compressor - thermal protection | Single phase - max 10A (2HP) |
| Product type | Electrical panel with electronics |
| Condenser - type of fans | Single phase |
| Condenser - Total fan power | up to 500 W |
| Condenser - separated fans | No |
| Evaporator- fans phases | Single phase |
| Evaporator - fans power | 500 W |
| Defrost - type | With heaters / off-cycle |
| Defrost - heaters phases | Single phase |
| Defrost - heaters power | 1500 W |
| Light - power | 800 W (AC1) |
| Other characteristics | Alarm relay, Door switch, Compressor oil heater, Telenet Pego supervision |
More info
• Direct control of the compressor, condenser fans, compressor oil heater, defrosting heaters, evaporator fans, solenoid valve, room light and all standard-compliant electrical safeguards.
• General magnetothermic circuit breaker accessible from the front panel, which cuts the general power supply.
• Easy wiring on the internal terminal block.
• Selection of functioning mode for the compressor (pump-down / thermostat).
• Auxiliary relay with activation configurable by parameter.
• Transparent cover for access to magnetothermic circuit breaker, all with IP 65 protection rating.
• Electronic control with wide LED display and easy to use buttons.
• Signaling with LED icons of the plant status.
• RS485 for connection to TeleNET industrial supervision network or modbus-RTU standard protocol.